how to use clone stamp tool in spectralayers pro 3

Sample All Layers: Use all layers to perform the cloning, not just the active layer. SOUND FORGE Pro has advanced editing and processing tools for any task. Location is an absolute source location (time and frequency). Heterogeneous acceleration allows using multiple video cards of different makes.

Pressure Controls Strength: When pressed, this enables devices with pressure control to set the strength of the tool.Īligned: When checked, the source location is a relative source location (distance to the source location). A soft brush (0%) will have blurry edges. Gain: Defines how much the content is amplified or reduced during cloning, in decibels.Ī hard brush (100%) will have clear edges.

Hardness: Defines the hardness of the brush in percents. Height: (Spectral Units only) Defines the height of the brush in hertz. Width: (Spectral Units only) Defines the width of the brush in seconds. Choose a Flow percentage (I usually leave this at. Choose an Opacity percentage (I usually leave this at 100, but may lower it depending upon the result I get at 100). In the Options bar at the top of the screen: Choose a soft-round brush. Size: (Screen Units only) Defines the size of the brush in pixels.Īspect Ratio: (Screen Units only) Defines the aspect ratio of the brush. Here’s how: Select the Clone Stamp Tool from the Tool Bar on the left. Screen Units / Spectral Units: Defines the units used to set the brush shape proportions. Round Brush / Square Brush: Defines the type of brush shape. After the source location has been defined the button will return to its initial, non-pressed state. Pick Source: Defines the source location by clicking in the spectrogram (or press Alt while clicking). Clone Stamp and Eraser Tool | Spectralayers Pro 7 TutorialsĬlone the content from a user-defined source location to the current brush location. Press Alt and click the image to define the clone starting point and area.

How to use clone stamp tool in spectralayers pro 3